General Introduction

PE jaw crushers are saftisfying most crushing requirements in primary and secondary crushing. Flexible setting of discharge opening of jaw crushers, that offer perfect match with relative equipment. They are easy to install, operate and maintain. PE Jaw Crusher is widely applied in mining, metallurgy, construction, smelting, hydropower and chemical industries etc.

Features: E-frame design, capable of with standing greater impact force, large diameter fly wheel structure, sturdy and durable, gasket type adjustment, firm and reliable.

Working Principle

The strip and strip pulley are driven by a motor, and the movable jaw movesup and down via eccentric shaft. The angle between fixed jaw and movable jaw becomes smaller when the movable jaw runs down, then the materialsare crushed into pieces. It will become bigger when the movable jaw runsup. The movable jaw board leaves the fixed jaw board under the action ofpole and spring, then the end products come out frme the crushing cavity.

        1. Assembly of flywheel

        2. Bearing house

        3. Bearing

        4. Eccentric shaft

        5. Back frame

        6. Toggle plate

        7. Toggle plate seat

        8. Spring

        9. Drawbar

        10. Front frame

        11. Movable jaw plate

        12. Fixed jaw plate

        13. Moving jaw assembly

        14. Side plate

Advantage

1. The application of advanced manufacturing processes and high-tech materials.

2. Integrated steel structures are used for the base of bearing.

3. The crushing chamber uses "V"-shaped structure, so that the feeding size is equal to the nominal one.

4. The crushing chamber is deep without dead zone, increasing the capacity and the output.

5. Lubrication system is safe and reliable, convenient to replace parts, easy to maintain.

6. The outlet employs shim adjustment system, convenient and reliable, and increasing the flexibility of the equipment.

7. Low noise, low dust rate.

Application

PE Jaw Crusher is widely used in mining, building materials chemical industry, metallurgy and so on. It is suitable forprimary and secondary crushing al kinds of mineras and rocks with compressive strength less than 320 Mpa.